Planning a Backyard Sauna and Cold Plunge in Dallas
How to lay out a sauna and cold plunge in a Texas backyard, and when an outdoor shower is enough.How to lay out a sauna and cold plunge in a Texas backyard, and when an outdoor shower is enough.
Hot and cold is the routine many sauna owners end up wanting: some time in the heat, a few minutes in cold water, rest, and repeat. It is easy to enjoy and surprisingly easy to lay out badly. Here is how to plan one in a North Texas backyard.
If you have a heart condition or high blood pressure, talk to your doctor first. Both heat and cold water put real demands on your body.
Start with the walk
You will make this walk wet and barefoot, often in the dark. Keep it short, flat and on a surface that is not slippery. Ideally the cold water is a few steps from the sauna door. A long walk across hot concrete in August, or cold concrete in January, is the fastest way to stop using the setup.
Plan the rest area too. A bench or two chairs between the sauna and the plunge is cheap, and it is the part of the routine people often forget.
Do you need a plunge at all?
Not always. A cold shower is the simplest cool-down. Several of our backyard builds, such as The Homestead in Joshua and The Glasshouse, include an outdoor shower beside the sauna. If you already have a pool, it can do the job for much of the year. The Plunge in The Colony was built around that idea: sauna, shower, then the pool a few feet away.
But a pool in a Dallas summer is warm. If you want truly cold water all year, you need a chiller.
Shade comes first
In July, a chiller in full sun has to fight hot air and hot concrete. It runs longer and it can struggle to hold temperature. Put the plunge where the house, a fence or a pergola shades it during the afternoon. Leave space around the chiller for airflow and for servicing. Keep the insulated cover on between uses.
Keep the sauna and the chiller apart
A sauna gives off heat, and a chiller rejects heat. Neither should be blowing on the other. Chillers also make some noise, so think about where your bedroom windows and your neighbors are.
Weight and base
Water is heavy. A 100-gallon plunge holds over 800 pounds of water before anyone gets in. It needs a level pad or a reinforced deck. Do not assume an existing deck can carry it. The sauna needs its own proper base, and in North Texas clay that base has to allow for seasonal soil movement. Planning both at once usually means one concrete pour and one site visit.
Electrical
A typical setup has two separate loads: the sauna heater, usually a dedicated 240V circuit, and the plunge, a dedicated GFCI-protected circuit. Check your panel capacity early, because a backyard spa often adds more load than people expect. A licensed electrician should do this work, and it normally needs a permit.
Drainage
You will drain the plunge sometimes, and the shower runs every session. Work out where that water goes. It should move away from the house, the sauna base and the pool. If your plunge uses sanitizer, check how you may discharge it. Do not leave this until after the concrete is poured.
Custom-built or ready-made?
A custom-built plunge can be set into a patio, faced in tile or stone, or framed in cedar to match the sauna. A ready-made unit is faster and easier to move later. We do both, and we also install plunges you have already bought. Our cold plunge page compares the two.
Permits
An outdoor sauna is usually an accessory structure, and the electrical work usually needs a permit. A built-in plunge can be treated more like a spa, with safety requirements of its own. See our DFW permits guide for what six cities publish.
Talk it through
We can design the sauna, the shower and the plunge as one project at a free consultation. Call (945) 371-8883 or send us a message.
Talk Through Your Project
Or call us directly: (945) 371-8883